3 Bar, 48 PSI, Boost Sensor for Diesel Engine

  • Model: AUBER-303

Ask a Question

$39.99

Add to Cart:

This pressure sensor is for diesel engine boost pressure measurements from -0.33 to 3.30 bar (or -5.0 to 48.0 PSI).  Unlike most of digital boost gauges on the market (and the other MAP sensor we offered), this sensor measures relative pressure (or gauge pressure) instead of absolute pressure. When not pressurized, the sensor will always give a zero pressure signal regardless of the elevation where the vehicle is at. It behaves the same way as the mechanical boost gauge.

When connected to the SYL-1813 Automobile Multimeter, the sensor will give you 0.01 bar or 0.1PSI resolution.
 

The sensor is supplied with a mating connector and 2 m (6ft) cable.
 

General Specifications:

Electrical:

Supply Voltage 5.0±0.5 VDC
Supply Current 10 mA max
Maximum Output Current Sink 1 mA
Source 0.1 mA
Output Impedance 10 ohms max
Output Type ratiometric
Output Voltage 0.1 to 4.85 VDC at 5VDC excitation

Sensor Operating Characteristics:

Range (relative pressure, or gauge pressure) -0.3 bar to 3.3 bar (-5.0 psi to 48 psi)
Proof Pressure 200%FS
Static Accuracy for -40 ~ 0 °C 3% FS
Static Accuracy for 0 ~ 80 °C 1% FS
Static Accuracy for 80 ~ 135 °C, 3% FS
 .

Environmental Effects:

Compensated Temperature Range -40°C to +135°C
Storage Temperature Range -50°C to +165°C

Mechanical:

Barb fitting OD: 0.25 inch; ID:0.11 inch
Compatibility Media: Air.

Note 1:  Static accuracy is the RSS of non-linearity, hysteresis, and non-repeatability
Note 2: Cable pin assignment: red is 5V power, green is ground, blue is signal.
 

This product was added to our catalog on Tuesday 16 November, 2010.

Copyright © 2024 auberins.com.