Product 7/9

Previous
Return to the Product List
Next

HeaterMeter 3D Printed Case with Defects

  • Model: SD-HMCase

Ask a Question

$16.00

Add to Cart:

These HeaterMeter enclosures are 3-D printed with black ABS fillament. Each enclosure has two halves that can be snapped together and are held by 4 sets of bolts/screws. Only the top halves have aesthetic defects on the surface. The bottom halves are in perfect condition.   

Please leave a message during check out to specify the item number. 
 

Item #                  Sensor Ports                       Top   
   		 Bottom
 		 Notes
 
A (sold) 2 x TCs, 
1 x thermistors		 Printed on film, smooth surface finish Printed on film, smooth surface finish Top and bottom half: slightly warped on the top right corner. 
B (sold) 1 x TC, 
3 x thermistors		 non-glossy finish non-glossy finish One small chip at the lower right corner. Repaired but still visible.  

 

 

 

 

 

 

 

Specifications
Condition: new with aesthetic defects.
Dimensions (W x D x H): 5.0 x 3.6 x 1.2" (127 x 92 x 30mm)


This product was added to our catalog on Friday 13 November, 2015.

Copyright © 2024 auberins.com.